SM74 Cutting and creasing jacket Duct Blades sharpness of wheel so it

sharpness of wheel so it is important to test for a satisfactory result

This is the totaliser counter used on several models

For longer runs 1

It features single action plate clamping and Bacher front pins which can be set for 220 or 425mm operation

This is the lever which pushes the rear plate clamp forward to fully grip the rear edge of the plate

SM74 Cutting and creasing jacket Duct Blades sharpness of wheel so itThe D plate is another part of the extensive PerfPrintPlus system for advanced in line die cutting and creasing operation on press. Consistent quality without any embossing of the sheet can be achieved by mounting this special hard jacket on the blanket cylinder. The precision backing set is also recommended. When Standard or Precision LithoPerf is mounted on the impression cylinder the sheets stay flat and high stacks can be run.